1.Preferred ViscosityNormal pump operation (at rated conditions) is based on the use of SAE 10W oil in the 38_ to 82_ C (100_ to 180_ F) range (or comparable viscosities). 2.Permissible Viscosity When operating with SAE 10W oil in the 860 to 40 cSt (4000 to 180 SUS) range (-12_ to 35_ C or 10_ to 95
View MorePump Start-up Procedure Preparation Prior to Start-up The reservoir and circuit should be clean and free of dirt and debris prior to filling with fluid. Circuit Cleanup The reservoir should be charged with filtered hydraulic fluid. The fluid level should be sufficient to prevent vortexing at the suc
View More1.Mounting Dimensions Requirements Dimensional control requirements of the customer’s mounting pad to which the pump or motor is affixed are as follows. Pilot Diameter Concentricity of the customer’s female pilot diameter relative to the effective axis of the female drive must be within 0,10 mm (.00
View More1.Preferred ViscosityNormal pump operation (at rated conditions) is based on the use of SAE 10W oil in the 38_ to 82_ C (100_ to 180_ F) range (or comparable viscosities). 2.Permissible Viscosity When operating with SAE 10W oil in the 860 to 40 cSt (4000 to 180 SUS) range (-12_ to 35_ C or 10_ to 95
Pump Start-up Procedure Preparation Prior to Start-up The reservoir and circuit should be clean and free of dirt and debris prior to filling with fluid. Circuit Cleanup The reservoir should be charged with filtered hydraulic fluid. The fluid level should be sufficient to prevent vortexing at the suc
1.Mounting Dimensions Requirements Dimensional control requirements of the customer’s mounting pad to which the pump or motor is affixed are as follows. Pilot Diameter Concentricity of the customer’s female pilot diameter relative to the effective axis of the female drive must be within 0,10 mm (.00